Configure ATM / Network Settings in Windows 2000 Note:
Ensure that you have successfully installed the Efficient 3060 Driver before you proceed the installation below
Connect the ADSL line to the Efficient 3060 Card
Please wait a while to see a wizard window appears as shown below
Unplug the ADSL line from the Efficient 3060 Card
Click on Next> button
Select "Manually enter connection information" and click on Next> button
Leave the default settings and click on Next> button
Select "PPP Over ATM VCMUX Encapsulation" and click on Verify button
Click on Save button
The driver will create 2 "SpeedStream DSL" icons at the Dial-Up Networking and Windows Desktop. These dialers are useless to the ATM Connection and we recommend you to delete them away as shown :
Go to windows desktop and select "SpeedStream DSL" icon
Right click on the mouse and select Delete option to remove it
Go to My Computer > Control Panel > Network and Dial-up Connections and select the "SpeedStream DSL" connection icon
Right click on the mouse and select Delete option
Click on Yes button to confirm
Ensure you are at Network and Dial-up Connections window
Next is to select "ATM Connection" icon
Right click of the mouse and select Properties option
Check the option "Show icon in taskbar when connected"
From the component window , check the options "ATM Call Manager" and "Internet Protocol"
Configure Internet Protocol
Select "Internet Protocol" and click on Properties button
Configure the settings as follows :
Check the option "Use the following IP address:"
IP address : please refer to the Service Letter
Subnet mask : 255.255.255.0
Default gateway : follow the IP address except last number is 2
Check the option "Use the following DNS server addresses:"
Preferred DNS server : 165.21.83.88
Alternate DNS server : 165.21.100.88
Click on Advanced... button
Click on ATM ARP Client Tab
Check the option "PVC only"
Click on OK button
Click on OK button to end Internet Protocol settings
Configure ATM Call Manager
Select "ATM Call Manager" and click on Properties button
Click on Add... button
From the Application type , select "ATM ARP" option
Configure the settings as follows :
Name : magix
Virtual path ID : 0
Virtual circuit ID : 101
ATM adaptation layer : AAL 5
Click on Advanced... button
If you see some values on the settings , leave the settings as default and click on OK button
Click on OK button to end ATM Call Manager settings
Click on OK button to end ATM / Network Settings
Please wait a while and you will see this icon appears at the taskbar
Double click on it
The status show that you are connected to Magix Service
You have successfully configured ATM / Network settings onto Windows 2000.
